Liza Lucy’s Go-To Mask Tutorial

Description

Liza’s Go-To Mask

 

Liza Prior Lucy is one of Kaffe Fassett‘s longtime design partners and a key member of The Kaffe Collective.

Liza and the whole team at The Kaffe Collective have been making masks since this pandemic began. Liza has, herself, made over 1000! She gives them to places to sell for the benefit of local food banks or, in the case of Kaffe’s family’s Phoenix Shop in Big Sur, for the benefit of the fire brigade. She has gotten rave reviews for the mask as they are comfortable and stylish. If you’re still looking for a fool proof pattern, we hope you’ll give this one a try.

MAKING MY MASKS
Cutting:
1. Cut 1 each of an outer fabric and a lining fabric.  8” x 8”
2. Cut two strips from outer fabric  1 ½” x 8”
3. Cut a firm piece of cardboard 2” x 12” and another 1” x 12”
4. Cut 2 pieces of elastic, each 7” long or longer if preferred.

Assembling and Pleating:
1. With right sides together sew the outer fabric to the lining using a ¼” seam.  Sew together at the top and bottom, leaving the sides unsewn.

2. Turn right side out and press seam.

3. Top stitch along both the top and bottom.

4. With lining facing up, place the 2” cardboard above the bottom sewn edge and turn up and press flat.

5. Do the same along the top edge, using the 1” cardboard.

**NOTE: The cardboard is used only for measuring and is slipped out after pressing the 2″ bottom and 1″ top creases. 

6. Fold the bottom pressed edge to meet the top pressed edge and iron flat.  This sets folds that will make pleating easy.

7. Unfold and with outer fabric facing up and the bottom edge closest to you, pinch the lowest fold and bring it half way down to the bottom edge. Then pinch the next fold to meet just above the first fold, and do it one more time to make the last pleat. Press well.

Binding the edges and attaching the elastic:

1. Place one of the outer fabric strips face against one of the raw edge sides, right sides together.

2. Fold about 3/8” of the strip over the top edge and place one end of a piece of elastic just below.

3. Sew to attach the strip and elastic using a ¼” seam.

4. Stop about ¾” from the bottom.

5. Cut the strip to about 3/8” below the bottom and fold up.

6. Place the other end of the elastic just above.

7. Sew to the end.

8. Repeat on the other side.

9. Open the binding with lining side up and finger press the top and bottom of the binding down toward the center. It helps to fold these at a bit of an angle, not straight down.

10. Fold the binding raw edge to the pleated edge of the mask and then fold again over the pleated edge and ends of the elastic.

11. Top stitch the binding down, reversing the stitching at the top and bottom to secure.

When I first started making these masks, I was inspired by a few key videos. I ended up changing them for my own preference and clarity. That said, I understand that some people do better with video content than a step-by-step, so I wanted to share those original videos here as well. For the pleating head HERE and for attaching the binding and elastic, head HERE. My masks are cut to a different size than the original and I do not insert the wire nose piece.  I also chose to add topstitching to ensure that the masks wear nicely through many launderings.

I used Kaffe’s Roman Glass in Red, & Aurifil 50wt threads.
We have to thank Liza for her kindness and generosity. We’re grateful for this tutorial and hope that you all find it helpful in moving through this next stage! Safe stitching!